Common quality problems of blow molding machines
1. The bottle is glued to the bottom mold:
a: The time of mold clamping operation and bottom mold rising operation do not match. It is recommended to check whether the solenoid valve of the bottom mold cylinder works normally.
b: The blow molding time is too short. Extend blow molding time.
c: No cooling water. Check cooling water.
2. The blowing machine cannot blow the bottle:
a: The heating temperature of the preform is too low. Strengthen the heating of the preform.
b: The pressure of the blowing air is too low. Confirm the pressure of the blowing air.
LONES Plastic Machinery Co., Ltd. is located in Huangyan Zone, Taizhou City, focusing on PET bottle design, semi-automatic and full-automatic bottle blowing machines, bottle mold manufacturing, pet preform, bottle cap molds etc as well as a series of product solutions; products are widely used In: mineral water, beverages, food, medicine, chemistry, reagents and other fields;
As always, the factory adheres to the concept of "Reputation priority, Service priority, Reliable quality", and manufactures bottle blowing machine with stable performance, low energy consumption, simple operation and durability to benefit every customer and provide customers with comprehensive technical support and services;
In more than ten years of business, the factory's equipment has been exported to Southeast Asia, the Middle East, Europe, South America, North America, Australia, Africa and other countries, and at the same time, received customer satisfaction reviews.